Suzuki 2008 Reno User Manual download pdf (Page 20)

1-8

SEATS AND RESTRAINT SYSTEMS

85Z14-03E

able to unbuckle the safety belt quickly

if you ever had to.

5) To make the lap part tight, pull down on

the buckle end of the belt as you pull up

on the shoulder belt.

The lap part of the belt should be worn low

and snug on the hips, just touching the

thighs. In a crash, this applies force to the

strong pelvic bones so you’d be less likely

to slide under the lap belt. If you slid under

it, the belt would apply force at your abdo-

men. This could cause serious or even

fatal injuries. The shoulder belt should go

over the shoulder and across the chest.

These parts of the body are best able to

take belt restraining forces.

The safety belt locks if there’s a sudden

stop or crash, or if you pull the belt very

quickly out of the retractor.

Shoulder Belt Height Adjuster

Before you begin to drive, move the shoul-

der belt adjuster to the height that is right

for you. Adjust the height so that the shoul-

der portion of the belt is centered on your

shoulder. The belt should be away from

your face and neck, but not falling off your

shoulder.

To move it down, squeeze the release but-

ton and move the height adjuster to the

desired position. You can move the

adjuster up just by pushing up on the

shoulder belt guide. After you move the

adjuster to where you want it, try to move it

down without squeezing the release button

to make sure it has locked into position.

L3U1022A

L3U1023A

S4U1009A

Safety Belts:

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 225 226

Comments to this Manuals

No comments